ASTM A883/A883M-01

    Withdrawn Standard: ASTM A883/A883M-01 Standard Test Method for Ferrimagnetic Resonance Linewidth and Gyromagnetic Ratio of Nonmetallic Magnetic Materials (Withdrawn 2006)

    Developed by Subcommittee: A06.01

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    3 pages
    $44.40


    Withdrawn Rationale:

    This test method covers the measurement of the ferrimagnetic resonance linewidth and gyromagnetic ratio of isotropic microwave ferrites. This test is restricted to spherical specimens possessing resonance linewidths greater than 10 Oe [796 A/m].

    Formerly under the jurisdiction of Committee A06 on Magnetic Properties, this test method was withdrawn in May 2006 due to lack of interest in its continued use.

    1. Scope

    1.1 This test method covers the measurement of the ferrimagnetic resonance linewidth and gyromagnetic ratio of isotropic microwave ferrites. This test is restricted to spherical specimens possessing resonance linewidths greater than 10 Oe [796 A/m].

    1.2 The values and equations stated in customary (cgs-emu and inch-pound) or SI units are to be regarded separately as standard. Within this standard, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    DOI: 10.1520/A0883_A0883M-01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top