ASTM A771/A771M-95(2001)

    Withdrawn Standard: ASTM A771/A771M-95(2001) Standard Specification for Seamless Austenitic and Martensitic Stainless Steel Tubing for Liquid Metal-Cooled Reactor Core Components (Withdrawn 2004)

    Developed by Subcommittee: A01.10

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    5 pages
    $50.40


    Withdrawn Rationale:

    This specification covers seamless annealed or cold-worked, austenitic or martensitic stainless steel tubing of 0.100 to 1.0 in. [2.5 to 25 mm] outside diameter with wall thickness of 0.050 in. [1.3 mm] or less for use at high temperature in liquid metal-cooled reactor plants.

    Formerly under the jurisdiction of Committee A01 on Steel, this specification was withdrawn without replacement in October 2004. This specification was developed for the sole support of, and application to, since-abandoned programs in a facility that no longer operates. No producer sponsors or user sponsors exist.

    1. Scope

    1.1 This specification covers seamless annealed or cold-worked, austenitic or martensitic stainless steel tubing of 0.100 to 1.0 in. [2.5 to 25 mm] outside diameter with wall thickness of 0.050 in. [1.3 mm] or less for use at high temperature in liquid metal-cooled reactor plants.

    1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    1.3 This specification and the applicable material specifications are expressed in both inch-pound and SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished in inch-pound units.


    DOI: 10.1520/A0771_A0771M-95R01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top