ASTM A752-04(2010)

Withdrawn Rationale:

This specification covers general requirements for alloy steel rods and uncoated coarse round alloy wire in coils that are not required to meet hardenability band limits. Formerly under the jurisdiction of Committee A01 on Steel, Stainless Steel, and Related Alloys, this specification was withdrawn in December 2011 and replaced by Specification A510/A510M for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel, and Alloy Steel.

1.1 This specification covers general requirements for alloy steel rods and uncoated coarse round alloy wire in coils that are not required to meet hardenability band limits.

1.2 In case of conflict, the requirements in the purchase order, on the drawing, in the individual specification, and in this general specification shall prevail in the sequence named.

1.3 The values stated in inch-pound units are to be regarded as the standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A370 Test Methods and Definitions for Mechanical Testing of Steel Products

A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment

A919 Terminology Relating to Heat Treatment of Metals

E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E30 Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron

E112 Test Methods for Determining Average Grain Size

AIAG Standard

Keywords

alloy; coarse round wire; general; wire rods; Coarse round steel wire; General delivery requirements--steel; Alloy steel wire--specifications; Steel wire rod--specifications; Structural steel (SS) plate--specifications; Structural steel (SS) wire;

Citing ASTM Standards

[Back to Top]