| ||Format||Pages||Price|| |
|23||$64.00||  ADD TO CART|
|Hardcopy (shipping and handling)||23||$64.00||  ADD TO CART|
This specification covers ductile iron gravity sewer pipe centrifugally cast with push-on joints. This also covers trench load design procedures for both cement-lined pipe and flexible-lined pipe. Maximum depths of cover tables are included for both types of linings. Each pipe shall be subjected to a hydrostatic test and maybe performed either before or after the outside coating and inside coating have been applied, but shall be performed before the application of cement-mortar lining or of a special lining. The standard acceptance tests and additional control tests shall also be performed.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers 4 to 64-in. ductile iron gravity sewer pipe centrifugally cast with push-on joints. This specification may be used for pipe with other types of joints, as may be agreed upon at the time of purchase.
1.2 This specification covers trench load design procedures for both cement-lined pipe and flexible-lined pipe. Maximum depth of cover tables are included for both types of linings.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D2487 Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System)
D3282 Practice for Classification of Soils and Soil-Aggregate Mixtures for Highway Construction Purposes
E8 Test Methods for Tension Testing of Metallic Materials
E23 Test Methods for Notched Bar Impact Testing of Metallic Materials
ANSI/AWWA StandardsC104/A21.4 Cement Mortar Lining for Ductile-Iron Pipe and Fittings for Water Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org. C111/A21.11 Rubber-Gasket Joints for Ductile-Iron Pressure Pipe and Fittings C150/A21.50 Thickness Design of Ductile-Iron Pipe C600 Installation of Ductile-Iron Water Mains and Their Appurtenances
ASCE StandardsManuals and Reports on Engineering Practice, No. (WCPF Manual of Practice No. 9). Design and Construction of Sanitary and Storm Sewers Available from American Society of Civil Engineers (ASCE), 1801 Alexander Bell Dr., Reston, VA 20191, http://www.asce.org.
AASHTO StandardAASHTO T-99 Standard Method of Test for the Moisture-Density Relations of Soils Using a 5.5 lb (2.5 kg) Rammer and a 12 in. (305 mm) Drop
ICS Number Code 23.040.10 (Iron and steel pipes)
UNSPSC Code 40170000(Pipe piping and pipe fittings); 31100000(Castings and casting assemblies)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A746-09(2014), Standard Specification for Ductile Iron Gravity Sewer Pipe, ASTM International, West Conshohocken, PA, 2014, www.astm.orgBack to Top