ASTM A700 - 14

    Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment

    Active Standard ASTM A700 | Developed by Subcommittee: A01.94

    Book of Standards Volume: 01.05


      Format Pages Price  
    PDF 5 $43.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $43.00   ADD TO CART


    Abstract

    These practices cover the packaging, marking, and loading of steel products for shipment, and are intended to deliver the products to their destination in good condition. It is also intended that these recommendations be used as guides for attaining uniformity, simplicity, adequacy, and economy in the shipment of steel products. These practices cover semi-finished steel products, bars, bar-size shapes and sheet pilings, rods, wire and wire products, tubular products, plates, sheets, and strips, tin mill products, and castings.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This guide covers the packaging, marking, and loading of steel products for shipment. Assuming proper handling in transit, this guide is intended to assist shippers in packaging and loading steel products to arrive at their destination safely and in good condition. It is also intended that this guide may be used for attaining uniformity, simplicity, sufficiency, and economy in the shipment of steel products.

    1.2 This guide applies to semi-finished steel products, bars, structural shapes and sheet piling, rods, wire and wire products, tubular products, plates, sheets, and strips, tin mill products, and castings.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D245 Practice for Establishing Structural Grades and Related Allowable Properties for Visually Graded Lumber

    D774/D774M Test Method for Bursting Strength of Paper

    D828 Test Method for Tensile Properties of Paper and Paperboard Using Constant-Rate-of-Elongation Apparatus

    D2555 Practice for Establishing Clear Wood Strength Values

    D3953 Specification for Strapping, Flat Steel and Seals

    Association of American Railroads

    Pamphlet23 --The Rules Governing the Loading of Steel Products in Closed Cars and Protection of Equipment

    American Society of Agricultural Engineers

    ASAEStandardS229, Baling Wire for Automatic Balers


    UNSPSC Code

    UNSPSC Code 81141601(Logistics)


    Referencing This Standard

    DOI: 10.1520/A0700-14

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM A700-14, Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment, ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top