ASTM A623M - 11

    Standard Specification for Tin Mill Products, General Requirements [Metric]

    Active Standard ASTM A623M | Developed by Subcommittee: A01.20

    Book of Standards Volume: 01.06


      Format Pages Price  
    PDF 25 $60.00   ADD TO CART
    Hardcopy (shipping and handling) 25 $60.00   ADD TO CART
    Standard + Redline PDF Bundle 50 $72.00   ADD TO CART


    Abstract

    This specification covers a group of common requirements which shall apply to tin mill products. The steel shall be made by the open-hearth, electric-furnace, or basic-oxygen process. The steel shall conform to specified chemical composition requirements. Rockwell 30T hardness test shall be done to the plates. This test forms the basis for a system of temper designation. The mechanical properties of continuously annealed plate and batch annealed plate of the same Rockwell 30T temper designation are not identical. It is important to keep in mind, that the Rockwell 30T test does not measure all various factors which contribute to the fabrication characteristics of the plate.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    Significance and Use

    1. Scope

    1.1 This specification covers a group of common requirements, which unless otherwise specified in the purchase order or in an individual specification, shall apply to tin mill products.

    1.2 In case of conflict in requirements, the requirements of the purchase order, the individual material specification,and this general specification shall prevail in the sequence named.

    1.3 The following safety hazards caveat covers Annex A1 through Annex A8 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1—A complete inch-pound companion to Specification A623M has been developedA623; therefore, no inch-pound equivalents are presented.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment

    A987 Practice for Measuring Shape Characteristics of Tin Mill Products

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    E112 Test Methods for Determining Average Grain Size

    Military Standards

    MIL-STD-163 Steel Mill Products, Preparation for Marking and Storage

    Federal Standard

    Fed.Std.No.123 Marking for Shipment (Civil Agencies)


    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 73181108(Tin plating service)


    DOI: 10.1520/A0623M-11

    ASTM International is a member of CrossRef.

    ASTM A623M

    Citing ASTM Standards
    Back to Top