ASTM A478 - 97(2013)

    Standard Specification for Chromium-Nickel Stainless Steel Weaving and Knitting Wire

    Active Standard ASTM A478 | Developed by Subcommittee: A01.17

    Book of Standards Volume: 01.03


      Format Pages Price  
    PDF Version 2 $37.00   ADD TO CART
    Print Version 2 $37.00   ADD TO CART


    Abstract

    This specification covers the commonly used types of round stainless steel wire intended especially for weaving and knitting. The steel shall conform to the requirements as to chemical composition specified. Wire shall be furnished in one of the following conditions: annealing, bright annealing, or cold drawing. The material shall conform to the requirements as to mechanical properties. The types of finish procurable are as follows: pickled finish and bright finish.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers the more commonly used types of round stainless steel wire intended especially for weaving and knitting.

    1.2 The values stated in inch-pound units are to be regarded as the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A555/A555M Specification for General Requirements for Stainless Steel Wire and Wire Rods

    A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products


    ICS Code

    ICS Number Code 77.140.20 (Steels of high quality); 77.140.65 (Steel wire, wir ropes and link chains)

    UNSPSC Code

    UNSPSC Code 31152203(Stainless steel wire)


    DOI: 10.1520/A0478

    ASTM International is a member of CrossRef.

    ASTM A478

    Citing ASTM Standards
    Back to Top