Abstract
This specification covers ferritic malleable castings for general engineering usage. The castings are classified as Grade 32510. The chemical composition of the iron shall be such as to produce the structural and mechanical properties required by this specification. Tension test may be machined from the standard cast bar to the required dimensions. The microstructure of the malleable iron shall consist of temper carbon nodules distributed through ferritic matrix and shall be free of excessive pearlite, massive carbides, and primary graphite. All castings, on visual examination, shall be sound and free of obvious shrinkage and porosity. The castings shall conform to the dimensions given by this specification.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers ferritic malleable castings for general engineering usage at temperatures from normal ambient to approximately 400°C (750°F).
1.2 No precise quantitative relationship can be stated between the properties of the iron in various locations of the same casting and those of a test specimen cast from the same iron (see Appendix X1).
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A153/A153M Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware
A247 Test Method for Evaluating the Microstructure of Graphite in Iron Castings
A644 Terminology Relating to Iron Castings
E8 Test Methods for Tension Testing of Metallic Materials
E10 Test Method for Brinell Hardness of Metallic Materials
E18 Test Methods for Rockwell Hardness of Metallic Materials
E140 Hardness Conversion Tables for Metals Relationship Among Brinell Hardness, Vickers Hardness, Rockwell Hardness, Superficial Hardness, Knoop Hardness, and Scleroscope Hardness
Military Standard
MIL-STD-129 Marking for Shipment and Storage
Federal Standard
Fed.Std.No.123 Marking for Domestic Shipment (Civilian Agencies)
Keywords
Engineering applications--specifications; Ferritic iron castings; Ferritic steel castings--specifications; Malleable iron castings--specifications; Pressure vessel iron;
ICS Code
ICS Number Code 77.140.80 (Iron and steel castings)
DOI: 10.1520/A0047_A0047M-99R09
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
