ASTM A392 - 11a

    Standard Specification for Zinc-Coated Steel Chain-Link Fence Fabric

    Active Standard ASTM A392 | Developed by Subcommittee: F14.40

    Book of Standards Volume: 01.06


      Format Pages Price  
    PDF 5 $43.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $43.00   ADD TO CART
    Standard + Redline PDF Bundle 10 $51.60   ADD TO CART


    Abstract

    This specification covers zinc-coated (galvanized) steel chain-link fence fabric, zinc coated either before or after weaving. The wire shall be woven throughout in the form of approximately uniform square mesh, having parallel sides and horizontal and vertical diagonals of approximately uniform dimensions. The top and bottom of the fabric shall be knuckled or twisted. A typical diamond count for each standard height is given. Chain-link fabric shall conform to the requirements specified for (1) mesh size, (2) wire size, (3) fabric height, (4) selvage, (5) zinc coating weight (Class 1or Class 2), and (6) breaking strength. The standard length of rolls and sampling requirements for testing are specified as well.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers zinc-coated steel chain-link fence fabric, zinc coated either before or after weaving.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A90/A90M Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment

    A817 Specification for Metallic-Coated Steel Wire for Chain-Link Fence Fabric and Marcelled Tension Wire

    B6 Specification for Zinc

    Federal Standard

    Fed.Std.No.123 Marking for Shipments (Civil Agencies) Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.

    Military Standards

    MIL-STD163 Steel Mill Products, Preparation for Shipment and Storage


    ICS Code

    ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)

    UNSPSC Code

    UNSPSC Code 31151609(Chain links); 11101704(Steel)


    Referencing This Standard

    DOI: 10.1520/A0392-11A

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM A392-11a, Standard Specification for Zinc-Coated Steel Chain-Link Fence Fabric, ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top