ASTM A216 / A216M - 14

    Standard Specification for Steel Castings, Carbon, Suitable for Fusion Welding, for High-Temperature Service

    Active Standard ASTM A216 / A216M | Developed by Subcommittee: A01.18

    Book of Standards Volume: 01.02


      Format Pages Price  
    PDF 4 $38.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $38.00   ADD TO CART
    Standard + Redline PDF Bundle 8 $45.60   ADD TO CART


    Abstract

    This specification covers carbon steel castings for valves, flanges, fittings, or other pressure-containing parts for high-temperature service and of quality suitable for assembly with other castings or wrought-steel parts by fusion welding. Covered here are three grades of carbon steel (Grades WCA, WCB, and WCC), the selection of which shall depend on the design and service conditions, mechanical properties, and the high temperature characteristics. Castings shall be heat treated and furnished, as appropriate to their design and chemical composition, in the annealed, or normalized, or normalized and tempered conditions after they have been allowed to cool below the transformation range. Furnace temperatures for heat treating shall be effectively controlled by pyrometer. Steel castings shall adhere to chemical composition and tensile property requirements, which include tensile strength, yield strength, elongation, and reduction of area. The surface of castings shall be free of adhering elements such as sand, cracks, hot tears, and other discontinuities, and as such be repair welded when judged appropriate.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification2 covers carbon steel castings for valves, flanges, fittings, or other pressure-containing parts for high-temperature service and of quality suitable for assembly with other castings or wrought-steel parts by fusion welding.

    1.2 Three grades, WCA, WCB, and WCC, are covered in this specification. Selection will depend upon design and service conditions, mechanical properties, and the high temperature characteristics.

    1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A488/A488M Practice for Steel Castings, Welding, Qualifications of Procedures and Personnel

    A703/A703M Specification for Steel Castings, General Requirements, for Pressure-Containing Parts

    A985/A985M Specification for Steel Investment Castings General Requirements, for Pressure-Containing Parts

    Manufacturers Standardization Society of the Valve and Fittings Industry Standard

    SP55 Steel Castings for Valve, Flanges, and Fittings, and Other Components (Visual Method)


    ICS Code

    ICS Number Code 77.140.80 (Iron and steel castings)

    UNSPSC Code

    UNSPSC Code 31101603(Steel sand casting)


    Referencing This Standard

    DOI: 10.1520/A0216_A0216M

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM A216 / A216M-14, Standard Specification for Steel Castings, Carbon, Suitable for Fusion Welding, for High-Temperature Service, ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top