You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM A1094 / A1094M - 16

    Standard Specification for Continuous Hot-Dip Galvanized Steel Bars for Concrete Reinforcement

    Active Standard ASTM A1094 / A1094M | Developed by Subcommittee: A01.05

    Book of Standards Volume: 01.04


      Format Pages Price  
    PDF 5 $44.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $44.00   ADD TO CART
    Standard + Redline PDF Bundle 10 $52.80   ADD TO CART


    1. Scope

    1.1 This specification covers steel reinforcing bars, with protective zinc or zinc-alloy coatings applied by the continuous hot-dip process.

    Note 1: The galvanizer is identified throughout this specification as the manufacturer.

    1.2 Guidelines for construction practices at the job-site are presented in Appendix X1.

    1.3 Guidelines for use of continuous hot-dip galvanized reinforcing bars with non-galvanized steel forms are presented in Appendix X2.

    1.4 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes shall not be considered requirements of the specification.

    1.5 This specification is applicable for orders in either inch-pound units (as Specification A1094) or SI units (as Specification A1094M).

    1.6 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents. Therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.

    1.7 This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A90/A90M Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

    A615/A615M Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement

    A706/A706M Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement

    A780/A780M Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings

    A996/A996M Specification for Rail-Steel and Axle-Steel Deformed Bars for Concrete Reinforcement

    B6 Specification for Zinc

    B487 Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section

    B852 Specification for Continuous Galvanizing Grade (CGG) Zinc Alloys for Hot-Dip Galvanizing of Sheet Steel

    E376 Practice for Measuring Coating Thickness by Magnetic-Field or Eddy-Current (Electromagnetic) Testing Methods


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A1094_A1094M-16

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM A1094 / A1094M-16, Standard Specification for Continuous Hot-Dip Galvanized Steel Bars for Concrete Reinforcement, ASTM International, West Conshohocken, PA, 2016, www.astm.org

    Back to Top