Gathering PDFs...

    ASTM D1275 - 06

    Standard Test Method for Corrosive Sulfur in Electrical Insulating Oils

    Active Standard ASTM D1275 | Developed by Subcommittee: D27.06

    Book of Standards Volume: 10.03

    Download Standard (PDF)
    3 pages
    View Text Version
    3 pages
    Standard + Redline (PDF)
    6 pages

    Historical (view previous versions of standard)

    Translated Standard: Russian
    more info

    ASTM D1275

    Significance and Use

    In most of their uses, insulating oils are continually in contact with metals that are subject to corrosion. The presence of corrosive sulfur compounds will result in deterioration of these metals. The extent of deterioration is dependent upon the quantity and type of corrosive agent and time and temperature factors. Detection of these undesirable impurities, even though not in terms of quantitative values, is a means for recognizing the hazard involved.

    1. Scope

    1.1 This test method describes the detection of corrosive sulfur compounds (both inorganic and organic) in electrical insulating oils of petroleum origin.

    1.2 New and in-service mineral insulating oils may contain substances that cause corrosion under certain conditions of use. This test method is designed to detect the presence of, or the propensity to form, free (elemental) sulfur and corrosive sulfur compounds by subjecting copper to contact with oil under prescribed conditions.

    1.3 Two methods (A and B) have been introduced where historically there has only been one. Method A is the one that has been in place since 1953. Method B is more rigorous and the preferred method.

    1.4 The values stated in SI units are to be regarded as the standard. Inch-pound units are included for informational purposes.

    This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D130 Test Method for Corrosiveness to Copper from Petroleum Products by Copper Strip Test

    Other Document

    ANSIB74.10 Grading of Abrasive Microgrits Available from American National Standards Institute, 25 W. 43rd St., 4th Floor, New York, NY 10036, USA.

    ICS Code

    ICS Number Code 29.040.10 (Insulating oils)

    UNSPSC Code

    UNSPSC Code 15121505(Transformer oil or insulating oil)

    DOI: 10.1520/D1275-06

    ASTM International is a member of CrossRef.

    ASTM D1275

    Citing ASTM Standards
    Back to Top