ASTM International
Standards
Books && Journals
Technical Committees
Membership
Meetings
Symposia
Training Courses
Proficiency Testing
Outsourcing Services
Lab Directory
Consultants Directory
About ASTM
Magazines && Newsletters
Newsroom && Information
Product Information
Get Product Updates
Request A Free Catalog
View Catalog
Standardization News Search
LoginSite MapOnline SupportContactPrivacy PolicyIP Policy
Site Search
 

         Bookmark and Share
View
Shopping Cart

Magazines & Newsletters / ASTM Standardization News

Contents | Standards Actions | Advertisers | Masthead | SN Archive | Rate Card | Subscriptions
Meetings Calendar | Talk to the Editor | Articulos escogidos en Español
Standards Search/Store | Technical Committees/Membership | News & Info | Site Map | ASTM Contacts
FREE Sample Magazine (Type Mailing Address into E-mail Message) | President's Column Archive
 April 2005 Tech News

Committee on Aromatic Hydrocarbons Revises Test Method for Calculation of Volume and Weight

ASTM International standard D 1555, Test Method for Calculation of Volume and Weight of Industrial Aromatic Hydrocarbons and Cyclohexane, and its metric equivalent, D 1555M, have been revised by Committee D16 on Aromatic Hydrocarbons and Related Chemicals. The revision affects the basis for correcting volume from any temperature to 60° F (or 15° C using D 1555M), as well as calculating the weight of product given the volume at a specific temperature.

Test Methods D 1555 and D 1555M are frequently used to calculate the mass of a quantity of material from the measured volume and temperature. The affected chemicals are: cyclohexane, benzene, toluene, mixed xylenes, styrene, ortho-xylene, meta-xylene, para-xylene, cumene, ethylbenzene and aromatic hydrocarbons.

The purpose of the revision was to make the standard more technically correct and adapt it to modern use. The most significant change is replacement of the volume correction factor table with equations that allow calculation of the VCFs in place of a manual interpolation from the original tables. This change will improve the precision of the procedure and allow the procedure to be integrated with automated techniques more easily. The VCFs, although now five places past the decimal, are no more than +/- 0.0001 different than the previous four-place VCFs, or +/- 0.01 percent. In addition, the densities at standard temperature for the pure materials are derived from densities furnished by NSRDS-NIST 75-121, published in 2001 (National Standard Reference Data Series - National Institute of Standards and Technology). These values are considered more accurate than the base densities determined in 1971.

CONTACT:
Technical Information:
Larry A. Montano
Chevron Phillips Chemical Co., the Woodlands, Texas
Phone: 832/813-4431

ASTM staff: Diane Rehiel
Phone: 610/832-9717

Upcoming Meeting: June 22-24,
Pittsburgh, Pa.

 
Site Map | Online Support | Contact | Web Policies | IP Policy
Copyright © 1996-2006 ASTM. All Rights Reserved.
ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA, 19428-2959 USA