Plastics

    NSF 14: Shaping the Future of the Plastic Piping Industry

    ASTM D 3350: A Historical and Current Perspective on a Standard Specification for Identification of Polyethylene Plastics Pipe and Fittings Materials

    Long-Term Hydrostatic Strength and Design of Thermoplastic Piping Compounds

    Deflection Lag, Load Lag, and Time Lag of Buried Flexible Pipe

    Polyamide 12 Natural Gas Distribution Systems Operating at Pressures Greater Than 125 Psig

    Technical Considerations When Fabricating PVC Pressure Fittings

    Design and Performance of Plastic Drainage Pipes in Environmental Containment Facilities

    How to Crawl Through a Pipe—Terminology

    Environmental Stress Cracking of Commercial CPVC Pipes

    Tensile Testing of a Push-On Restrained Joint PVC Pipe

    North America’s Cinderella Pipe Story: A Look at PVC Pipes’ Climb to the Top

    A Service Life Assessment of Corrugated HDPE Drainage Pipe

    A Brief History of the Development and Growth of the Corrugated Polyethylene Pipe Industry in North America

    Influencing Factors of Heat Transfer Coefficient in Air and Gas Quenching

    The Hydrostatic Stress Board of Plastics Pipe Institute: The First 50 Years

    Axial Response of HDPE Pipes as a Result of Installation by Directional Drilling

    Building Knowledge from Failure Analysis of Plastic Pipe and Other Hydraulic Structures

    Unique Calibration Case Study for Predictive Model of Installation Loads for Directional Drilled Fusible PVC Pipe

    Plastic Tubing Prospect to Replace Cast Iron Conduit in Steam Heating Systems

    Trenchless Case History—University of Denver’s Use of High-Performance Restrained-Joint Water Distribution Pipe

    Challenges in Investigating Chlorinated Polyvinyl Chloride Pipe Failures

    Yesterday, Today, and Now: Polyamide-11 Gas Piping at 200 psig Under the New Rules

    Designing Stormwater Chambers to Meet AASHTO Specifications

    Guided Side-Bend: An Alternative Qualification Method for Butt Fusion Joining of Polyethylene Pipe and Fittings

    Stress Crack Protocol for Finished Product Testing of Corrugated High Density Polyethylene Pipe