Publish With ASTM
Book Guide
Journals
Login
Site Map
Online Support
Contact
Web Policies
IP Policy
Site Search
Home
Journals
STPs
Manuals
Topics
Subscriptions/Pricing
Digital Library/Symposia/E08/Fatigue and Fracture Mechanics: 35th Volume
Sponsored by ASTM committee E08 on Fatigue and Fracture
May 18 2005 - May 20 2005
Papers Published from this Symposium
An Investigation of Specimen Geometry Effects on the Fracture Behavior of a Polytetrafluoroethylene Polymer
Verification of Analytical Models in a Fracture Mechanics Based Approach to Modeling Fretting Fatigue
Effect of Microstructure on Pit-to-Crack Transition of 7075-T6 Aluminum Alloy
Mechanistic Studies of High-Temperature Crack Initiation in Single Crystal Materials
Asymptotic Stress Fields for Thermomechanically Loaded Cracks in FGMs
Elastic -Stress Solutions of Embedded Elliptical Cracks Subjected to Uniaxial and Biaxial Loadings
An Experimental and Numerical Study of the Fracture Strength of Welded Structural Hollow Section X-Joints
Detection of Crack Initiation by Observations of Free Surface Condition
Constraint Corrected - Curve and Its Application to Fracture Assessment for X80 Pipelines
Observations on Photo-Emission and the Process Zone of a Fatigue Crack
Volumetric and Surface Positron Annihilation Studies of Fatigue Damage Accumulation in a Steel Alloy
Application of the Reference Temperature to the Evaluation of Cleavage Fracture in HSLA-100 Steel
Creep Crack Growth Predictions in Component Using a Damage Based Approach
Creep Crack Growth Analysis of Welded Joints for High Cr Heat Resisting Steel
Fatigue Strength in Presence of Inhomogeneities: Influence of Constraint
The Effect of Large Strain Cycling on the Fatigue Strength of Welded Joint
Anomalous Fatigue Crack Growth Data Generated Using the ASTM Standards
Simulation on the Decrease in Threshold Stress Intensity Factor (SIF) Range due to High Maximum SIF
Analysis of Creep Crack Initiation and Growth in Different Geometries for 316H and Carbon Manganese Steels
European Code of Practice for Creep Crack Initiation and Growth Testing of Industrially Relevant Specimens
Prediction of Scatter in Creep Crack Growth Data from Creep Failure Strain Properties
Trends in High Temperature Structural Integrity Assessment
Surface Roughness, Quasi-Static Fracture, and Cyclic Fatigue Effects on GFRP- and CFRP-Concrete Bonded Interfaces
Temperature Dependence and Variability of Fracture Toughness in the Transition Regime for A508 Grade 4N Pressure Vessel Steel
Use of Miniaturized Compact Tension Specimens for Fracture Toughness Measurements in the Upper Shelf Regime
Analysis of Dynamic Fracture and Crack Arrest of an HSLA Steel in an SE(T) Specimen
Probabilistic Analysis of the Creep Crack Growth Rate of Type 316LN Stainless Steel by the Monte Carlo Simulation
Modelling the Redistribution of Residual Stresses at Elevated Temperature in Components
Site Map
|
Online Support
|
Contact
|
Privacy Policy
|
IP Policy
Copyright © 1996-2006 ASTM. All Rights Reserved.
ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA, 19428-2959 USA
