Publish With ASTM
Book Guide
Journals
Login
Site Map
Online Support
Contact
Web Policies
IP Policy
Site Search
Home
Journals
STPs
Manuals
Topics
Subscriptions/Pricing
Digital Library/Symposia/E08/Fatigue and Fracture Mechanics: 34th Volume
Sponsored by ASTM committee E08 on Fatigue and Fracture
November 19 2003 - November 21 2003
Papers Published from this Symposium
Structural Reliability Analysis of Railroad Tank Cars Subjected to Fatigue and Corrosion
Load History Effects Resulting from Compression Precracking
Use of ACR Method to Estimate Closure and Residual Stress Free Small Crack Growth Data
Size Effect of Microdamage Growth and Its Relation to Macro Fatigue Life
The Effect of Load Reduction Scheme on Crack Closure in the Near-Threshold Regime
Selection of Material for Welded Steel Structures Based on Fracture Mechanics
Fractographic Reassessment of the Significance of Fatigue Crack Closure
A New Method for Opening Load Determination from Compliance Measurements
Assessment for Decrease in Threshold Stress Intensity Factor (SIF) Range Due to High Maximum SIF
Notch-Root Elastic-Plastic Strain-Stress in Particulate Metal Matrix Composites Subjected to General Loading Conditions
Assessment of Plane Stress Tearing in Terms of Various Crack Driving Parameters
Evaluation of Fatigue Crack Thresholds Using Various Experimental Methods
Modeling of Three-Dimensional Effects on Fatigue Crack Closure Processes in Small-Scale Yielding
Ultrasonic Fatigue Testing of Ti-6Al-4V
Fretting Fatigue and Stress Relaxation Behaviors of Shot-Peened Ti-6Al-4V
Crack Initiation, Propagation, and Arrest in 316L Model Pipe Components under Thermal Fatigue
Simulation of Fatigue Crack Propagation in Railway Axles
The Effect of Negative Stress Ratio Load History on High Cycle Fatigue Threshold
Interpretation of Material Hardness, Stress Ratio, and Crack Size Effects on the of Small Cracks Based on Crack Closure Measurement
Analysis of Roughness-Induced Crack-Tip Shielding in Terms of Size Ratio Effect
Influence of Crack-Surface Oxidation on Creep-Fatigue Crack Behavior of 1Cr- and 10Cr-Steels
Temperature Dependent Fracture Toughness of a Single Crystal Nickel Superalloy
Critical Assessment of the Standard ASTM E 399
Effect of Residual Stresses on the Fatigue Crack Propagation in Welded Joints
On the Constraint-Based Failure Assessment of Surface Cracked Plates under Biaxial Loading
Construction of J-R Curves Using the Common and Concise Formats
Environmentally Influenced Fatigue in High Strength Steels
Characterization of Crack Length Measurement Methods for Flat Fracture with Tunneling
Evaluation of the Effect of Crack Tip Constraint on Fatigue Crack Growth Rate in Inconel 718
Effect of Periodic Overloads on Threshold Fatigue Crack Growth in Al-Alloys
Evaluation of the Effect of Biaxial Loading on the T Reference Temperature Using a Cruciform Specimen Geometry
Fatigue Crack Growth Rate and Stress-Intensity Factor Corrections for Out-of-Plane Crack Growth
Sensitivity of Creep Crack Initiation and Growth in Plates to Material Properties Variations
Microstructural Influences on the Development and Growth of Small Fatigue Cracks in the Near Threshold Regime
Site Map
|
Online Support
|
Contact
|
Privacy Policy
|
IP Policy
Copyright © 1996-2006 ASTM. All Rights Reserved.
ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA, 19428-2959 USA
