|
|
|
SEDL / STP / STP645-EB
 |
STP645
Fractography in Failure Analysis
Strauss BM, Cullen WH
Pages: 382
Published: 1978
|
|
Deals with application of state-of-the-art fractography techniques and interpretations to material failures. Twenty papers cover four broad areas-techniques, environmental effects, fatigue and stress and nonmetals.
Table of Contents
Introduction
Cullen W., Strauss B.
Summary
Cullen W., Strauss B.
Application of Fractographic-Microstructural Correlations in Evaluating Failure Mechanisms in Two Types of Steels
Lentz D., Steele J.
Use of Laboratory Failure Simulation Exemplars to Study Intergranular Fracture Modes in 9Ni-4Co-0.20C Steel
Kumar A., Young J.
Case Histories Illustrating Fractographic Analysis Techniques
Meyn D.
Fractographic Method of Evaluation of the Cyclic Stress Amplitude in Fatigue Failure Analysis
Albertin L., Madeyski A.
Fractographic Analysis of Gaseous Hydrogen Induced Cracking in 18Ni Maraging Steel
Gangloff R., Wei R.
Analysis of Fracture Morphology of Hydrogen-Assisted Cracking in Steel and Its Welds
Araki T., Kikuta Y., Kuroda T.
Fracture of Ti-8Al-1Mo-1V Alloy Fan Blade by Stress Corrosion Cracking and Fatigue
Lee E., Mahorter R., Wacaser J.
Effect of the Cyclic Rate on Corrosion Fatigue and Fractography of Type 304 Stainless Steel in Boiling 42 Percent Magnesium-Chloride Solution
Hioki S., Muhai Y.
Fractographic Observation of Stress-Corrosion Cracking of AISI 304 Stainless Steel in Boiling 42 Percent Magnesium-Chloride Solution
Mukai Y., Murata M., Watanabe M.
Metallurgical Characterization of the Fracture of Aluminum Alloys
Bhandarkar M., Lisagor W.
Use of Microfractography in the Study of Fatigue Crack Propagation under Spectrum Loading
Abelkis P.
Fractographic and Metallographic Morphology of Fatigue Initiation Sites
Eylon D., Kerr W.
Fractographic Analysis of Low Cycle Fatigue Specimens from a Failed Steam Turbine Rotor
Kramer L.
Role of Interface Chemistry in Failure of Materials
Joshi A.
Examination of Fracture in a Pressure Vessel under Creep Conditions
Coleman M.
Strength, Toughness, and Flaw Tolerance of 25.4-mm (1-in.) Alloy Steel Lifting Chain
McCartney R., Pellegrino J.
Effect of the Amount and Shape of Inclusions on the Directionality of Ductility in Carbon-Manganese Steels
Inoue T., Kaneko K., Kinoshita S., Takada H.
Comparison of the Threshold Stress Intensities and Fracture Characteristics for Temper Embrittled and Deembrittled 2¼ Cr-1M0 Steel in a Hydrogen Charging Environment
Gilmore C., Hicho G.
Fractographic Analysis of Ceramics
Freiman S., Mecholsky J., Rice R.
Index
Committee: E08
Paper ID: STP645-EB
DOI: 10.1520/STP645-EB
ISBN-EB: 978-0-8031-5547-3
 ASTM International is a member of CrossRef.
0-8031-0359-X
978-0-8031-0359-7
STP645-EB
|
