|
|
|
SEDL / STP / STP521-EB
 |
STP521
Analysis of the Test Methods for High Modulus Fibers and Composites
Whitney JM
Pages: 408
Published: 1973
|
|
The papers in the symposium on Analysis of the Test Methods for High Modulus Fibers and Composites were presented at a meeting held in San Antonio, Tex., 12-13 April 1972. The symposium was sponsored by The American Society for Testing and Materials through its Committee D30 on High Modulus Fibers and Their Composites. J. M. Whitney, Air Force Materials Laboratory, Wright-Patterson Air Force Base, presided as symposium chairman. Carl Zweben, Materials Science Corporation, and R. J. Diefendorf, Rensselaer Polytechnic Institute, presided as symposium vice-chairmen for Composites and Fibers, respectively.
Table of Contents
Introduction
Whitney J.
Characterization of Composites for the Purpose of Reliability Evaluation
Halpin J., Jerina K., Johnson T.
Fracture Mechanics and Composite Materials: A Critical Analysis
Zweben C.
Fracture Mechanics for Fibrous Composites
Badaliance R., Hilton P., Shenberger P., Sih G., Villarreal G.
Method for Estimating Fracture Strength of Specially Orthotropic Composite Laminates
Cruse T., Konish H., Swedlow J.
Deformation and Failure of Boron-Epoxy Plate with Circular Hole
Daniel I., Rowlands R., Whiteside J.
Free-Edge Effects in the Characterization of Composite Materials
Whitney J.
Effects of Specimen Geometry on the Strength of Composite Materials
Kaminski B.
Compressive Strength and Failure Modes of Unidirectional Composites
Greszczuk L.
Influence of the Free Edge upon the Strength of Angle-Ply Laminates
Kaminski B., Pagano N., Pipes R.
Data Averaging of Anisotropic Composite Material Constants
Jerina K., Lavengood R., Wu E.
Pure Bending of Helical Wound Composite Cylinders
Pagano N.
Prediction and Control of Macroscopic Fabrication Stresses in Hoop Wound, Fiberglass Rings
Reuter R.
Some Important Aspects in Testing High-Modulus Fiber Composite Tubes in Axial Tension
Chamis C., Sullivan T.
Post-Yielding Behavior of Torsionally Loaded Composite Tubes
Foye R., Lantz R.
Ultrasonic Procedures for Inspecting Composite Tubes
Carson J., Leidel D., Rose J.
Determination of the Mechanical Properties of Fiber Composites by Ultrasonic Techniques.
Dean G., Lockett F.
Influence of Fiber Property Variation on Composite Failure Mechanisms
Mullin J.
Graphite Fiber Tensile Property Evaluation
McMahon P.
High-Strength Filaments for Cables and Lines
Scala E.
Committee: D30
Paper ID: STP521-EB
DOI: 10.1520/STP521-EB
ISBN-EB: 978-0-8031-4621-1
 ASTM International is a member of CrossRef.
0-8031-0701-3
978-0-8031-0701-4
STP521-EB
|
