|
|
|
SEDL / STP / STP477-EB
 |
STP477
Determination of the In Situ Modulus of Deformation of Rock
Committee D-18
Pages: 205
Published: 1970
|
|
The National Materials Conservation Symposium on Resource Recovery and Utilization was held 29 April-1 May 1974 at the National Bureau of Standards in The symposium was sponsored by: National Bureau of Standards; Bureau of Mines; Environmental Protection Agency; National Center for Resource Recovery, Inc.; and American Society for Testing and Materials. Harvey Alter, National Center for Resource Recovery, Inc., and Emanuel Horowitz, National Bureau of Standards, served as the symposium cochairmen.
Table of Contents
Introduction
Deere D.
Discussion
General Discussion
Wallace G.
In Situ Methods for Determining Deformation Modulus Used by the Bureau of Reclamation
Anderson F., Slebir E., Wallace G.
Analysis of Data from Radial Jacking Tests
Misterek D.
New Techniques in Deformability Testing of In Situ Rock Masses
Rocha M.
Deformability of Rock Structures, California State Water Project
Kruse G.
Modulus Testing of Rock at the Churchill Falls Underground Powerhouse, Labrador
Benson R., McCreath D., Murphy D.
Development of Equipment for Determining Deformation Modulus and In Situ Stress by Means of Large Flatjacks
Boisen B., Deklotz E.
Pressure Meter Testing of Soft Bedrock
Dixon S.
Compressibility Characteristics of Shales Measured by Laboratory and In Situ Tests
Gamble J., Hendron A., Mesri G., Way G.
Predicting In Situ Modulus of Deformation Using Rock Quality Indexes
Coon R., Merritt A.
The Deformability of Joints
Goodman R.
Committee: D18
Paper ID: STP477-EB
DOI: 10.1520/STP477-EB
ISBN-EB: 978-0-8031-4590-0
 ASTM International is a member of CrossRef.
0-8031-0047-7
978-0-8031-0047-3
STP477-EB
|
