|
|
|
SEDL / STP / STP432-EB
 |
---->
STP432
Applications Related Phenomena in Titanium Alloys
Conrad H, Jaffee RI, Kessler HP, Minkler WW
Pages: 294
Published: 1968
|
|
The Symposium on Applications Related Phenomena in Titanium Alloys was presented 18-19 April 1967 in Los Angeles, Calif. ASTM Committee B10 on Reactive and Refractory Metals and Alloys sponsored the symposium. Hans Conrad, University of Kentucky, was the symposium chairman. It was divided into four sessions, and presiding as chairmen of these sessions were Dr. Conrad; R. I. Jaffee, Battelle Memorial Institute; H. P. Kessler, Reactive Metals, Inc.; and W. W. Minkler, Titanium Metals Corporation of America.
Table of Contents
Introduction
Conrad H.
Sources of Fracture Toughness: The Relation Between KIc and the Ordinary Tensile Properties of Metals
Hahn G., Rosenfield A.
A Review of Factors Influencing the Crack Tolerance of Titanium Alloys
Brown W., Shannon J.
Structural Ductility of High Strength Titanium Alloys
Papirno R.
Toughness of Two-Phase 6Al-4V Titanium Microstructures
Baker G., Gerberich W.
Relation of Strength and Toughness to Fine Structures in a Beta Titanium Alloy
Banerjee B., Capenos J., Hauser J.
Plane Strain Fracture Toughness and Mechanical Properties of 5Al-2.5Sn ELI and Commerical Titanium Alloys at Room and Cryogenic Temperatures
Carman C., Katlin J.
Metallurgical and Mechanical Aspects of the Sea-Water Stress Corrosion of Titanium
Cavallaro J., Lane I.
The Influence of Composition and Heat Treatment on the Aqueous-Stress Corrosion of Titanium
Hall G., Seagle S., Seeley R.
Effects of Heat Treating Environmental Conditions on the Stress-Corrosion Cracking Resistance of Several Titanium Alloys
Goode R., Howe D.
The Initiation of Hot-Salt Stress Corrosion Cracking of Titanium Alloys
Rideout S.
Crevice Corrosion of Titanium
Boyd W., Jackson J.
Biaxial Properties of Titanium Alloys at Cryogenic Temperatures
Corn D., Frederick S.
Texture Strengthening and Fracture Toughness of Titanium Alloy Sheet at Room and Cryogenic Temperatures
Sullivan T.
Effects of a 3.5 Per Cent Sodium Chloride Aqueous Saline Environment on the Fatigue Crack Propagation Characteristics of Titanium Alloys
Crooker T., Lange E.
Lubricants and Wear Coatings for Titanium
Kostman S.
Surface Treatment of Ti-6Al-4V for Impact-Fatigue and Wear Resistance
Koves G., Weltzin R.
Committee: B10
Paper ID: STP432-EB
DOI: 10.1520/STP432-EB
ISBN-EB: 978-0-8031-4571-9
 ASTM International is a member of CrossRef.
0-8031-0748-X
978-0-8031-0748-9
STP432-EB
|
