STP1508: Biaxial Loading Effect on Higher-Order Crack Tip Parameters

    Shlyannikov, V. N.
    Research Center for Power Engineering Problems of the Russian Academy of Sciences, Kazan,

    Ilchenko, B. V.
    Research Center for Power Engineering Problems of the Russian Academy of Sciences, Kazan,

    Boychenko, N. V.
    Research Center for Power Engineering Problems of the Russian Academy of Sciences, Kazan,

    Pages: 32    Published: Jan 2009


    Abstract

    The higher-order asymptotic crack-tip fields are considered for a Mode I in power-law plastic and creeping materials under plane strain conditions. Using an asymptotic expansion and separation of variables for the stress function, a series solution is obtained for stress components at a crack tip. In addition, full-field finite element analysis based on a modified layer approach is employed to model the effects of biaxial loading on nonlinear behavior. Loadings were applied related to a range of biaxial stress ratio (−2, +2). The radial and angular stress distributions and higher-order amplitude coefficients for plastic materials are obtained. Crack tip higher-order fields under various conditions of biaxial loading and spanning the range of times from small scale creep to extensive creep are presented. Account is taken of the radial distance accompanying crack tip blunting. The phenomenon of stress redistributions along crack plane on creep time as a function of biaxial stress ratio is stated. The regions of dominance of the HRR-type field under various biaxial stress ratio, crack distance, hardening exponent, and creep time are found. Good agreement analytical findings with finite element results conforms that HRR-solution corresponds only to the equibiaxial tension which is a particular case of biaxial loading. It is further demonstrated that the higher-order both for plastic and creeping fields are controlled through constraint parameter A2 by biaxial stress ratio. By fitting numerical results for plastic and creeping materials, two empirical formulas were obtained to describe the higher-order terms amplitude coefficients A2 distributions depending on biaxial stress ratio, crack distance, hardening exponent, and creep time.

    Keywords:

    biaxial loading, higher-order terms, constraint parameter, crack-tip field, plane strain, plastic and creeping materials


    Paper ID: STP48789S

    Committee/Subcommittee: E08.08

    DOI: 10.1520/STP48789S


    CrossRef ASTM International is a member of CrossRef.