STP353: Quality Control for Lumber Products

    Williston, E. M.
    Technical director, lumber, Wood Products Div., Weyerhaeuser Co., Longview, Wash

    Pages: 7    Published: Jan 1964


    Abstract

    This paper describes procedures used during manufacture to control the quality of dimension and finish lumber, end- and edge-glued lumber, water-repellent-treated wood products, prime painted products, and laminated beams. A test method is outlined for comparing the extractive stain resistance of paints applied to cedar or redwood siding. A novel method is described for ascertaining the degree of sticking or blocking that will occur during shipment of factory-painted lumber.


    Paper ID: STP45117S

    Committee/Subcommittee: D07.02

    DOI: 10.1520/STP45117S


    CrossRef ASTM International is a member of CrossRef.