STP342: Portable Low-Cost Polyethylene Ultraclean Assembly Areas

    Trace, C. K.
    Sperry Rand Corp., Gainesville, Fla.

    White, J. M.
    Sperry Rand Corp., Gainesville, Fla.

    Rich, C. E.
    Sperry Rand Corp., Gainesville, Fla.

    Pages: 5    Published: Jan 1963


    Abstract

    This paper presents a concept in the design and construction of ultraclean assembly areas for use in the electron tube industry. The construction costs of this room may be reduced to approximately 10 per cent of costs normally encountered in conventional clean rooms by using nylon reinforced polyethylene for the entire enclosure.

    The discussion is divided into two sections: the design, construction, and operation of the clean room; and, secondly, the monitoring and detection of contaminants. Employment of the principles established as good practice in clean-room operations has resulted in an efficient, low-cost installation


    Paper ID: STP44474S

    Committee/Subcommittee: F01.10

    DOI: 10.1520/STP44474S


    CrossRef ASTM International is a member of CrossRef.