STP1022

    Measurements of the Forces Needed to Take Off Classic and Rear Entry Ski Boots

    Published: Jan 1989


      Format Pages Price  
    PDF (276K) 7 $25   ADD TO CART
    Complete Source PDF (7.1M) 7 $87   ADD TO CART


    Abstract

    Because of concern with the difficulties encountered when removing rear entry ski boots from patients with lower limb injuries, an investigation was undertaken to determine if there are significant differences between the forces necessary to remove a rear entry boot and those necessary to take off a normal entry boot.

    This laboratory study used an articulated foot with an ankle joint. The angles of the ankle's joint were measured, and the pulling forces necessary to remove the foot from various models of usual and rear entry ski boots were recorded.

    Records were kept of several different people attempting to remove the boots. It was found that while it was possible to remove normal entry boots from the dummy's foot using reasonable force and without disturbing the foot's position, this was not the case with rear entry boots. In fact, according to the several different candidates, either extra forces were required or the position of the ankle joint had to be altered.

    Practice and training play a great part in this removal. It has been proven that a doctor trained in the methods of removing boots from the injured skier uses a lower pulling force than an engineer not familiar with such methods.

    Removing the boot without disturbing the ankle joint and using only reasonable force should be added to the existing standards concerning ski boots presently set by the industry.

    Keywords:

    ankle injury, leg injury, ski boots


    Author Information:

    Binet, M-H
    Centre Medical, Le Pas du Lac, Avoriaz,

    Montillet, B
    Annecy,

    Delouche, G
    Chemin de la Prairie prolongé, Annecy,

    Thomas, M
    Chemin de la Prairie prolongé, Annecy,


    Paper ID: STP19466S

    Committee/Subcommittee: F27.30

    DOI: 10.1520/STP19466S


    CrossRef ASTM International is a member of CrossRef.