STP1111: Oxygen Compatibility of High-Surface-Area Materials

    Dunbobbin, BR
    Engineering Associate, Senior Engineering Associate, and Hazards Research Specialist, Air Products and Chemicals, Inc., Allentown, PA

    Hansel, JG
    Engineering Associate, Senior Engineering Associate, and Hazards Research Specialist, Air Products and Chemicals, Inc., Allentown, PA

    Werley, BL
    Engineering Associate, Senior Engineering Associate, and Hazards Research Specialist, Air Products and Chemicals, Inc., Allentown, PA

    Pages: 16    Published: Jan 1991


    Abstract

    High-surface-area metallic structured packings are finding increasing use in the cryogenic distillation of air. An experimental program was performed to determine the oxygen compatibility of selected metals under the high-surface-area-to-volume ratios and adiabatic conditions encountered in commercial use.

    Under some conditions brass packing unexpectedly had a higher relative flammability than aluminum, which is contrary to reported test results using metal rods and strips. This is due, we believe, to the specific geometric and adiabatic configuration of the packing material which appears to enhance the propagation of combustion in brass. Aluminum flammability in gaseous oxygen has been shown to be very dependent upon argon dilution and, in the presence of liquid oxygen, strong energy releases have been observed, similar to those experienced with aluminum powder and liquid oxygen. Copper was found to be nonpropagating in all tested oxygen purities.

    These findings suggest that results from oxygen compatibility tests on rods and strips cannot be used reliably for ranking the suitability of materials in high-surface-area-to-volume ratio and adiabatic configurations.

    Keywords:

    Oxygen compatibility, aluminum, brass, stainless steel, copper, surface area effect, combustion propagation, structured packing, air separation, flammability


    Paper ID: STP17773S

    Committee/Subcommittee: G04.02

    DOI: 10.1520/STP17773S


    CrossRef ASTM International is a member of CrossRef.