STP1067

    Simple Test Method for Evaluating Exterior Wall Airtightness of Tall Office Buildings

    Published: Jan 1990


      Format Pages Price  
    PDF (312K) 15 $25   ADD TO CART
    Complete Source PDF (5.3M) 15 $68   ADD TO CART


    Abstract

    C. Y. Show, D. M. Sander, and G. T. Tamura developed a test method to measure the air leakage characteristics of exterior walls of buildings that utilized an outdoor air supply system of ventilation and air handling, taking into account the influence of the stack effect. They applied this method to eight tall buildings in Ottawa, and results were reported.

    However, windows and wall constructions in Japan are so different than those in Canada that those results cannot be used directly. To obtain our own data, the authors developed a simple test method that utilizes buoyancy caused by the stack effect instead of fans for pressurization. To open doors on the ground floor or the window at the bottom part of the building while the stack effect is operative is the same as pressurizing the whole building, and to open an exit door at the roof or the window at the upper part of the building is the same as decompressing the whole building.

    This method was applied to three tall buildings of Sendai and Tokyo, whose walls were cast-in-place concrete (Building A), precast concrete panel (Building B), and metal panel (Building C). For the test results, infiltration rates through the exterior wall were estimated by approximate calculation. Of the three, it was found that Building A was the tightest and Building C was the loosest. This paper reports the results of the application for the simple test method we developed.

    Keywords:

    exterior-wall, airtightness, test method, stack effect, tall building


    Author Information:

    Hayakawa, S
    Chief research engineer and senior research engineer, Kajima Institute of Construction Technology, Tokyo,

    Togari, S
    Chief research engineer and senior research engineer, Kajima Institute of Construction Technology, Tokyo,


    Paper ID: STP17218S

    Committee/Subcommittee: E06.55

    DOI: 10.1520/STP17218S


    CrossRef ASTM International is a member of CrossRef.