STP1545

    Evaluation of Sealed Joint Performance for the Selection of Sealants Suitable for Use in Autoclaved Lightweight Concrete Panels

    Published: Jul 2012


      Format Pages Price  
    PDF (1.4M) 19 $25   ADD TO CART
    Complete Source PDF (56M) 19 $139   ADD TO CART


    Abstract

    The strength of autoclaved lightweight concrete (ALC) is evidently lower than that of normal concrete. Therefore, when movement occurs at a sealed joint between ALC panels, the sealant is required to deform and remain intact without damaging the ALC substrate. However, there is currently not sufficient information to permit evaluation of the expected performance of sealants applied to ALC substrates. In this study, static and dynamic tests were carried out in order to obtain an index that could be used to select the modulus of a sealant that can be expected to provide long-term performance when applied to an ALC substrate. To develop this index, an initial study was carried out in order to clarify actual joint movement between ALC panels of buildings; the expansion and contraction at the joint were measured, and shear joint movement was calculated based on the expected story-to-story drift of an external wall due to earthquake loads. Thereafter, in a subsequent stage of the study, five types of two-component polyurethane sealant products, of different elastic modulus, were subjected to tensile and shear tests from which the relationship between stress and the type of joint fracture was determined. The results from these tests revealed that when the stress is greater than 0.6 to 0.7 N/mm2, the ALC substrate is more easily fractured than the sealant. In a final stage of the study, the cyclic fatigue resistance of the same two-component sealants was evaluated using tensile and shear fatigue tests. Results from the fatigue tests indicated that the high modulus sealants lost adhesion from the ALC substrate at an early stage in the test. As well, the fatigue resistance of test specimens with joints having three-sided adhesion was lower than that of specimens having normally configured joints with adhesion on two sides of the sealant. Therefore, on the basis of results derived from all the studies, it was determined that a suitable sealant for use on ALC substrates is a sealant having a low modulus that is applied in the normal fashion as a two-sided joint.

    Keywords:

    sealant, autoclaved lightweight concrete, wall panel, modulus, fracture


    Author Information:

    Miyauchi, Hiroyuki
    Assistant Professor, Doctor of Engineering, Dept. of Architectural Engineering, Chungnam National Univ., Daejeon,

    Lacasse, Michael A.
    Senior Research Officer, National Research Council Canada, Institute for Research in Construction, Ottawa,

    Murata, Shigeki
    Scientific committee member, ALC Association, Tokyo,

    Enomoto, Noriyoshi
    Scientific committee member, Doctor of Engineering, Japan Sealant Industry Association, Tokyo,

    Tanaka, Kyoji
    Emeritus Professor, Doctor of Engineering, Tokyo Institute of Technology, Kanagawa,


    Paper ID: STP154520120018

    Committee/Subcommittee: C24.30

    DOI: 10.1520/STP154520120018


    CrossRef ASTM International is a member of CrossRef.