Development of a Non-Destructive Evaluation Practice of Installed Weatherproofing Sealant Joints Using a Rolling Device—An Introduction to ASTM C 1736

    Published: Jul 2012

      Format Pages Price  
    PDF (660K) 9 $25   ADD TO CART
    Complete Source PDF (56M) 9 $139   ADD TO CART


    This paper provides an overview of the development of standardized methodology to evaluate joint seal continuity, encompassed in the newly published ASTM C 1736-11, “Standard Practice for Non-Destructive Evaluation of Adhesion of Installed Weatherproofing Sealant Joints Using a Rolling Device.” This standard practice was created under the jurisdiction of ASTM Committee C 24 on Building Seals and Sealants and is the direct responsibility of Subcommittee 30 on Adhesion; it was approved July 1, 2011. Fundamental details contributing to the successful usage of this practice are examined by answering the following questions: Where exactly do the stresses produced by this procedure have an effect upon the sealant-to-substrate bond-line? How does joint geometry impact this bond-line stress? What level of stress on a bond-line provides usable information without damaging the seal?


    ASTM C 1736, continuous sealant evaluation, cured, joint, non-destructive evaluation, rolling device, sealant failure in adhesion

    Author Information:

    Huff, Daniel N.
    Independent Researcher, Salem, OR

    Committee/Subcommittee: C24.30

    DOI: 10.1520/STP154520120016

    CrossRef ASTM International is a member of CrossRef.