STP1412

    Effects of Fine Aggregate Angularity on VMA and Rutting of Kansas HMA Mixtures

    Published: Jan 2001


      Format Pages Price  
    PDF Version (248K) 15 $25   ADD TO CART
    Complete Source PDF (4.1M) 15 $91   ADD TO CART


    Abstract

    With the recent introduction of Superpave, mix designers in Kansas have had difficulty meeting the voids in the mineral aggregate (VMA) requirements. To meet VMA, designers have been importing chat, a flaky fine aggregate of nearly pure chert produced as a by-product from lead and zinc mining, to boost VMA.

    The objectives of this research were to evaluate the effect of fine aggregate angularity (FAA) on VMA and rutting. Two 12.5-mm Superpave gradations, one coarse and one fine, were developed using 100% crushed limestone. To change the FAA of the mix, the fine aggregate was replaced with natural sand and chat, a byproduct from lead and zinc mining. The resultant VMA and FAA of each blend was compared and samples were tested for rutting.

    The results indicate that increased FAA results in greater VMA, after exceeding a minimum, and decreased rutting. Chat was shown to be effective at increasing VMA but reduced stability. Meeting Superpave mix requirements did not insure a stable mix.

    Keywords:

    VMA, aggregate angularity, rutting, Superpave


    Author Information:

    Cross, SA
    Associate Professor and Graduate Research Assistant, University of Kansas, Lawrence, KS

    Purcell, EM
    Associate Professor and Graduate Research Assistant, University of Kansas, Lawrence, KS


    Paper ID: STP10802S

    Committee/Subcommittee: D04.51

    DOI: 10.1520/STP10802S


    CrossRef ASTM International is a member of CrossRef.