Volume 35, Issue 3 (May 2007)

    Combination of Transient Plane Source and Slug Calorimeter Measurements to Estimate the Thermal Properties of Fire Resistive Materials

    (Received 22 November 2005; accepted 28 August 2006)

    Published Online: 2006

    CODEN: JTEOAD

      Format Pages Price  
    PDF Version 5 $25   ADD TO CART


    Abstract

    The thermal properties of fire resistive materials (FRMs) as a function of temperature critically influence their ability to protect a (steel) structure during a fire exposure. Measurement of these properties is complicated by the microstructural heterogeneity of typical FRMs, the need to measure properties over a wide temperature range from room temperature to 1000°C and higher, and the reactions, phase changes, and volumetric changes that the materials may undergo during exposure to elevated temperatures. This paper presents an integrated approach for determining thermal properties via a combination of two experimental techniques, namely the transient plane source and the slug calorimeter methods. The former is utilized to provide an estimate of the volumetric heat capacity and a room temperature thermal conductivity value for the FRM under study, while the latter is employed to estimate the variation in effective thermal conductivity with temperature, including the influences of reactions and mass transport during multiple heating/cooling cycles. The combination of the two techniques is demonstrated for four different inorganic-based FRMs. Their extension to organic (intumescent) systems is also discussed.


    Author Information:

    Bentz, DP
    Chemical Engineer, National Institute of Standards and Technology, Gaithersburg, MD


    Stock #: JTE100033

    ISSN: 0090-3973

    DOI: 10.1520/JTE100033

    ASTM International is a member of CrossRef.

    Author
    Title Combination of Transient Plane Source and Slug Calorimeter Measurements to Estimate the Thermal Properties of Fire Resistive Materials
    Symposium , 0000-00-00
    Committee E05