ISSN: 0090-3973
Page Count: 7

Ultimate Strength of Resistance Spot Welds Subjected to Combined Tension and Shear
Lee, YL
Chrysler Corporation, MI

Wehner, TJ

Lu, M-W

Morrissett, TW

Pakalnins, E

Abstract

A new test setup and data concerning the ultimate strength behavior of resistance spot welds in a mild strength steel subjected to combined tension and shear loads are presented. A test plan based on a design of experiments (DOE) with three design factors (coupon width, coupon length, and nugget diameter) was conducted to investigate the influence of the factors on the ultimate strength of the resistance spot welds under different loading angles. In this program, test loads were monotonically applied to the resistance spot weld at a specific angle until the load carrying capacity of the resistance spot weld was exceeded. It was found that the nugget diameter contributes the most (more than 70%) to the total variation of the recorded ultimate strength and that the coupon length has little effect. A deterministic ultimate strength model was proposed to take into account the interaction of in-plane shear and 90° out-of-plane tensile loading in the resistance spot weld. A reliability model was also demonstrated to evaluate the ultimate strength of a single resistance spot weld.

Keywords:
resistance spot weld, ultimate strength, combined tension and shear, reliability, design of experiments, sheet metal

Paper ID: JTE11994J
DOI: 10.1520/JTE11994J
ASTM International is a member of CrossRef.