EPR/PTFE Dosimetry for Test Reactor Environments

    Volume 9, Issue 5 (May 2012)

    ISSN: 1546-962X


    Published Online: 1 May 2012

    Page Count: 11

    Vehar, D. W.
    Sandia National Laboratories, Albuquerque, NM

    Griffin, P. J.

    Quirk, T. J.

    (Received 8 June 2011; accepted 10 February 2012)


    In 1992 the Radiation Metrology Laboratory (RML) at Sandia National Laboratories implemented EPR/Alanine capabilities for use in routine and calibration activities at its Co-60 and pulsed-power facilities. At that time it also investigated the usefulness of the system for measurement of absorbed dose in the mixed neutron/photon environments of reactors such as the Sandia Pulsed Reactor and the Annular Core Research Reactor used for hardness testing of electronics. The RML concluded that the neutron response of alanine was a sufficiently high fraction of the overall dosimeter response that the resulting uncertainties in the photon dose would be unacceptably large for silicon-device testing. However, it also suggested that non-hydrogenous materials such as polytetrafluoroethylene (PTFE) would exhibit smaller neutron response and might be useful in mixed environments. Preliminary research with PTFE in photon environments indicated considerable promise, but further development was not pursued at that time. Because of renewed interest in absorbed dose measurements that could better define the individual contributions of photon and neutron components to the overall dose delivered to a test object, the RML has re-initiated the development of an EPR/PTFE dosimetry system. This paper presents a summary of the research, a description of the EPR/PTFE dosimetry system, and recommendations for preparation and fielding of the dosimetry in photon and mixed neutron/photon environments.

    Paper ID: JAI104051

    DOI: 10.1520/JAI104051

    ASTM International is a member of CrossRef.

    Title EPR/PTFE Dosimetry for Test Reactor Environments
    Symposium , 0000-00-00
    Committee E10