Published Online: 13 January 2014
Page Count: 14
Assistant Professor, Department of Civil Engineering, The German University in Cairo, Cairo,
Assistant Professor, Department of Engineering Technology, New Jersey Institute of Technology, Newark, NJ
Field Engineer, EE Cruz & Company, Inc., New York, NY
(Received 18 May 2013; accepted 21 October 2013)
Visual soil classification methods used for estimating fines content are often relied upon in geotechnical investigations. The estimations of these methods are highly judgmental, generally erratic, and typically necessitate a confirmation. Laboratory mass-based wash tests are regularly performed on selected soil samples in order to verify or complement in situ visual classifications. Therefore, there is a dire need to improve the accuracy of fines content estimates of the visual methods. A preliminary study was conducted to assess the principle of estimating fines content by measuring relative volumes of the coarse-grained to fine-grained soil fractions. The results indicated soundness and adequacy of the principle. Utilizing this volume-based concept and the standard sample washing methods, a pilot study was conducted to develop and evaluate a more precise testing method, the mold test. Triplicate test runs were carried out on 144 soil samples. With run times of 5 to 15 min, the test is sufficiently rapid. The estimated fines contents of the samples were compared with that determined by the ASTM D1140 test. The absolute differences between the two estimates fell within ±5 % range, which is an appreciably higher accuracy than those of commonly used visual soil classification methods. Analysis performed on the results of the pilot study attested statistical competences of the proposed test method. This study has proven that the mold test is convenient for measuring fines content in soils at almost no cost—except minor consumables. The test method eliminates the subjectivity associated with current visual classification tests as well as the time and cost of the standard laboratory wash tests. While it is not intended to be a substitute for the latter, the mold test is an economically viable option that maintains balance between laboratory accuracy and practicality of the field methods.
Paper ID: GTJ20130095