Volume 24, Issue 2 (April 2002)

    The Design of In-Plane Shear and Tension-Loaded Bonded Composite Lap Joints

    (Received 18 December 2000; accepted 5 September 2001)

    CODEN: CTROAD

      Format Pages Price  
    PDF Version 11 $25   ADD TO CART


    Abstract

    The stress analysis of a bonded joint carrying combined in-plane shear and tension load is presented. A general equation is derived that governs the transfer of shear load through a joint. For the case of uniform in-plane shear loading, a closed-form solution exists that is directly analogous to the well-known tension-loaded case. When shear and tension loads are simultaneously applied to a joint, the results of stress analyses treating each loading case separately are superimposed to calculate a combined biaxial shear stress state in the adhesive. Predicting the elastic limit of the adhesive for a lap joint under combined loading is then accomplished by using the von Mises yield criterion. This approach allows the calculation of a limit load envelope that maps the range of combined loading conditions within which the joint is expected to behave elastically. An example design case study of a bonded I-beam shear web is included.


    Author Information:

    Kim, H
    Assistant Professor, School of Aeronautics and Astronautics, Purdue University, West Lafayette, IN

    Kedward, KT
    Professor, University of California, Santa Barbara, CA


    Stock #: CTR10970J

    ISSN: 0884-6804

    DOI: 10.1520/CTR10970J

    ASTM International is a member of CrossRef.

    Author
    Title The Design of In-Plane Shear and Tension-Loaded Bonded Composite Lap Joints
    Symposium , 0000-00-00
    Committee D30