ISSN: 0884-6804
Page Count: 9

The Wyoming-Modified Two-Rail Shear Test Fixture for Composite Materials
Hussain, A
University of Wyoming, WY

Adams, D
University of Wyoming, WY

Abstract

A significantly modified two-rail shear fixture with a new clamping concept and enhanced gripping capability has been designed, fabricated, and evaluated. This new fixture solves some of the major shortcomings associated with the ASTM Standard D 4255 Two-Rail Shear test procedure, including limited specimen gripping ability, the need for specimens with holes, and potential failure by out-of-plane buckling. The in-plane unidirectional ply shear properties of AS4/3501-6 carbon/epoxy were measured using specimens of [0/90]^3S cross-ply orientation. Repeatable results and acceptable failure modes were obtained. The excellent gripping capability of the new test fixture was also demonstrated in tests of an AS4/3501-6 carbon/epoxy [±45]^4S angle-ply composite, a very high shear strength material.

Keywords:
shear test fixture, composite materials, two-rail test

Paper ID: CTR10984J
DOI: 10.1520/CTR10984J
ASTM International is a member of CrossRef.