1. Scope
1.1 This test method specifies procedures and apparatus used for testing and evaluating fitness equipment for compliance to Specification F 2276. Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced.
1.2 It is the intent of this test method to specify fitness products for use by adult users only. Dimensions set forth in this test method are based on adult anthropometrics. Further, instructions and warnings defined by this test method are written for adults and are not expected to be read or understood by children.
1.3 Requirements--Fitness equipment is to be tested for all of the following parameters:
1.3.1 Stability.
1.3.2 Edge and Corner Sharpness.
1.3.3 Tube Ends and Holes.
1.3.4 Function of Adjustments and Locking Mechanisms.
1.3.5 Handgrip Design and Retention.
1.3.6 Foot Supports.
1.3.7 Load Development and Transmitting Systems.
1.3.8 Chain and Gear Drive Design.
1.3.9 Entrapment Zones and Guarding.
1.3.10 Loading and Deflection.
1.3.10.1 Intrinsic Loading.
1.3.10.2 Extrinsic Loading.
1.3.10.3 Endurance Loading
1.3.11 Electrical Guarding
1.3.12 Maximum Surface Temperature
1.3.13 Documentation and Warnings Verification.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
This is the companion document to recently approved Specification F 2276.
Keywords
fitness equipment; exercise machines; treadmills; steppers; stair climbers; weight machines; strength equipment; exercise bikes; ICS Number Code
The title and scope are in draft form and are under development within this ASTM Committee.
Citing ASTM Standards
[Back to Top]
