ASTM WK9866

    Work Item: ASTM WK9866 - New Test Method for Test Method for Analysis of Tin-Based Solder Alloys for Lead, Cadmium, Mercury, Antimony and Bismuth (and others) Using Inductively Coupled Plasma Atomic Emission Spectrometry

    (What is a Work Item?)

    Developed by Subcommittee: F40.01 | Committee F40 | Contact Staff Manager



    1. Scope

    1. Scope 1.1 These test methods cover procedures for the analysis of tin-based solder alloys for lead, cadmium, mercury, antimony, bismuth (and others) using inductively coupled plasma atomic emission spectrometry (ICP-AES) instrumentation. 1.2 The range of concentrations of lead for which these test methods have been validated is ________for Method A and _______ for Method B. This range may be extended for higher concentrations through dilution procedures given for each method. 1.3 The range of concentrations of cadmium for which these test methods have been validated is ________for Method A and _______ for Method B. This range may be extended for higher concentrations through dilution procedures given for each method. 1.4 The procedures appear in the following order: Preparation of Calibration Solutions Preparation of Sample and Validation Solutions Calibration Method A: Direct Analysis Method B: Indirect Analysis Using Method of Additions 1.5 Values stated in SI units are to be regarded as the standard. Any values given in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    No such standard exists.


    Keywords

    Lead; cadmium; solder; Inductively Coupled Plasma Atomic Emission Spectrometry; ICP-AES; declarable substances

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    12-20-2005

    Technical Contact:
    Susan Evans Norris

    Status:
    Draft Under Development