ASTM WK45422

    Revision of D2683 - 10e2 Standard Specification for Socket-Type Polyethylene Fittings for Outside Diameter-Controlled Polyethylene Pipe and Tubing

    (What is a Work Item?)

    Active Standard: D2683 - 10e3

    Developed by Subcommittee: F17.10 | Committee F17 | Contact Staff Manager



    WK45422

    1. Rationale

    Revise or eliminate Table 4 which specifies Lay Lengths or G dimensions for Tees and Elbows. The existing table we believe is not intended to be an absolute minimum given there is no tolerance specified. Other similiar socket fusion fitting standards such as the one for Polypropylene do not even have such a table and leave it up to the designer to determine the minimum lay length dimensions and still meet all other performance and socket fusion dimensional requirements. The principal goal of the 1st task group in Toronto is to solicit input from fitting manufacturers who currently produce to this standard.


    Keywords


    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    03-18-2014

    Technical Contact:
    Gary Morgan

    Item:
    001

    Ballot:
    F17 (14-04)

    Status:
    Ballot Item Approved as D2683-2014 and Pending Publication