ASTM WK45199

    Revision of C916 - 85(2007) Standard Specification for Adhesives for Duct Thermal Insulation

    (What is a Work Item?)

    Active Standard: C916 - 85(2007)

    Developed by Subcommittee: C16.33 | Committee C16 | Contact Staff Manager



    WK45199

    1. Rationale

    Update revisions by adding a clarification on unit values used in the standard, and update the fire caveat. Item 1: Concurrent For ASTM C916: Standard Specification for Adhesives for Duct Thermal Insulation Add new Section 1.2 addressing unit values used in the standard. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Item 2: Concurrent For ASTM C916: Standard Specification for Adhesives for Duct Thermal Insulation Replace current 7.7.1 which is an outdated fire caveat to the current fire caveat approved by E5 Fire Standards. Current Wording: 7.7.1 This test should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. Proposed Wording: 7.7.1 This standard is used to measure and describe the response of materials, products, or assemblies to heat an flame under controlled conditions, but does not by itself incorporate all factors required for fire-hazard or fire-risk assessment of the materials, products, or assemblies under actual fire conditions.


    Keywords

    adhesive; duct liner; insulation; Acoustical materials/applications specifications; Adhesion thermal insulating materials; Air conditioning materials/applications specifications; Bond strength adhesives; Ducts/duct liners; Edge burning test; Thermal insulating materials specifications; Ventilation materials/applications (buildings);
    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    02-24-2014

    Technical Contact:
    Richard Gebhart

    Item:
    014

    Ballot:
    C16 (14-02)

    Status:
    Ballot Item Approved as C916-2014 and Pending Publication

    Item:
    015

    Ballot:
    C16 (14-02)

    Status:
    Ballot Item Approved as C916-2014 and Pending Publication