ASTM WK43311

    New Specification for 12- to 60-in. [300- to 1500-mm] Annular Corrugated Profile Wall Polyethylene (PE) Pipe Containing Recycled PE for Gravity Flow Storm Sewer and Subsurface Drainage Applications

    (What is a Work Item?)

    Developed by Subcommittee: F17.62 | Committee F17 | Contact Staff Manager



    WK43311

    1. Scope

    1.1 This specification covers requirements and test methods for annular corrugated profile wall polyethylene pipe with an interior liner. The inside diameters covered are 12 to 60 in. [300 to 1500 mm]. 1.2 The requirements of this specification are intended to provide nonpressure (gravity flow) pipe and fittings suitable for underground use for nonpressure storm sewer and subsurface drainage systems. Pipe and fittings produced in accordance with this specification shall be installed in compliance with Practice D2321. 1.3 This specification covers pipe and fittings with an interior liner using an annular exterior corrugated profile. 1.4 Units-The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents. Therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to its use.

    Presently, governmental entities are in need of a corrugated HDPE standard for recycled pipe material that has a long-term service life and stress crack resistance that is comparable to that of virgin HDPE corrugated pipe. This standard will give the governmental agencies a corrugated HDPE pipe standard to meet their needs.


    Keywords

    profile wall; interior liner; pipe; fittings; PE; subdrainage; land drainage; polyethylene; recycled

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    08-28-2013

    Technical Contact:
    Tim Toliver

    Item:
    001

    Ballot:
    F17.62 (14-04)

    Status:
    Negative Votes Need Resolution