1. Scope
1. Scope 1.1. These test methods specify procedures and equipment used for testing and evaluating stationary exercise bicycles and crank training equipment [machines] for compliance to Specification F1250. Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced. In case of a conflict between this document and Specification F 1250, Specification F1250 takes precedence. 1.2. Requirements Stationary exercise bicycles and crank training equipment are to be tested for the parameters specified in F2276 and F2571 and the following parameters unique to this equipment: 1.2.1.Seat post construction and loading 1.2.2.Handlebar construction and loading 1.2.3.Pedal construction and loading 1.2.4.Seat backrest loading 1.2.5.Stability 1.2.6.Warnings 1.2.7.Documentation 1.3.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use
F1250 is being revised into a specification and test method and this document is the test method
Keywords
10.1Exercise bicycle, spinning, freewheel, flywheel, recumbent
The title and scope are in draft form and are under development within this ASTM Committee.
Citing ASTM Standards
[Back to Top]
