1.1.This practice covers the properties, application, and performance of a two component resin based Membrane-Forming Moisture Mitigation System prior to the installation of resilient flooring. 1.2.This practice includes recommendations for the preparation of the concrete surface to receive a two component resin based Membrane-Forming Moisture Mitigation System. 1.3.This practice does not supersede written instructions of the two component resin based Membrane-Forming Moisture Mitigation System manufacturer, the resilient flooring manufacturer, underlayments manufacturer, the adhesive manufacturer and/or other components of the finish flooring system. Users of this practice shall review manufacturers technical data sheets and installation instructions for compatibility of system components. 1.4.The following Membrane-Forming or non membrane forming Moisture Mitigation Systems are not included in the scope of this document. Moisture mitigation systems that chemically react with any constituent of the concrete to form a gel or crystalline substance within the concrete, Penetrating, water-or solvent-based compounds, that do not form a continuous membrane on the concrete surface and Water based Membrane-Forming Moisture Mitigation Systems are not included in the scope of this document. 1.5.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.6.The values stated in inch-pound units are to be regarded as standard. The values in parentheses are mathematical conversions to SI units and are provided for information only.
The title and scope are in draft form and are under development within this ASTM Committee.Back to Top
Ballot Item Approved as F3010-2013 and Pending Publication