ASTM WK31925

    New Test Method for Creep Testing of Fibers

    (What is a Work Item?)

    Developed by Subcommittee: D13.19 | Committee D13 | Contact Staff Manager



    WK31925

    1. Scope

    1.1 This test method covers the measurement of creep for a fiber. This test method includes testing procedure only and does not include specifications or tolerances. 1.2 This test method shows the values in both SI and inch-pound units. SI units is the technically correct name for the system of metric units known as the International System of Units. Inch-pound units is the technically correct name for the customary units used in the United States. The values stated in either acceptable metric units or other units shall be regarded separately as standard. The values expressed in each system may not be exact equivalents; therefore, each system must be used independently of each other, without combining values in any way. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations

    There are currently no standards written for the measurement of creep of fibers. The primary users will be manufacturers of high-performance fibers and their direct customers.


    Keywords

    creep

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    02-03-2011

    Technical Contact:
    Dawn Caullwine

    Status:
    Draft Under Development