ASTM WK17626

    Work Item: ASTM WK17626 - New Guide for Using Fluorescence Microscopy to Quantify the Spread Area of Fixed Cells

    (What is a Work Item?)

    Developed by Subcommittee: F04.46 | Committee F04 | Contact Staff Manager



    1. Scope

    1.1 This practice guide describes several measurement and technical issues involved in quantifying the spread area of fixed cells. Cell spreading and the distribution of cell spread areas of a population of cells are the result of a biological response that is dependent on cell state and the characteristics of cell adhesion to a surface. Cell spread area is a morphological feature that can indicate an alteration in the metabolic state or state of stress of the cells. Changes in cell spread area can also indicate an alteration in the adhesion substrate that may be due to differences in manufacturing of the substrate material or be in response to cell extracellular matrix secretions. High quality measurement of cell spread area can serve as a useful metric for benchmarking cell behavior and cell state under experimental conditions. 1.2 This measurement described in this document is based on the use of fluorescence microscopy imaging of cells and the use of image analysis algorithms to extract relevant data from the images. To produce robust cell spread area measurements, technical details involved in sample preparation, cell staining, microscopy imaging, image analysis and statistical analysis should be considered. Several of these issues are discussed within this document. 1.3 This document is meant to serve as a guide for developing methods to reliably measure the area to which cells spread at a surface. This surface can be conventional tissue culture polystyrene or sophisticated engineered biomaterial surfaces. An example of a detailed procedure to measure the spreading area of cells on a tissue culture polystyrene surface is provided in the appendix section. 1.4 Cell morphology features such as cell spreading area and perimeter are generally reported in units of length. For example, spreading area per cell (e.g. cell spread area) is likely reported in units of um2. A spatial calibration standard is required to convert between numbers of pixels in a CCD camera image to um2 as an SI unit. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    government, biotechnology industry, academic, biomaterials quality control, cell therapy community


    Keywords

    Automated microscopy, cell morphology, cell culture, segmentation, image analysis, fluorescence microscopy, cell staining, biomaterials, cytotoxicity, tissue engineering, cell therapy, stem cells, differentiation, quality control

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    12-04-2007

    Technical Contact:
    John Elliott

    Item:
    023

    Ballot:
    F04 (13-06)

    Status:
    Ballot Item Approved

    Item:
    029

    Ballot:
    COS (13-12)

    Status:
    Ballot Item Approved as F2998-2014 and Pending Publication