1. Scope
1. Scope 1.1. These test methods specify procedures and equipment used for testing and evaluating elliptical trainers for compliance to Specification X XXXX. Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced. In case of a conflict between this document and Specification X XXXX, Specification X XXXX takes precedence. 1.2. RequirementsAn elliptical trainer is to be tested for all of the following parameters: 1.2.1.Endurance, 1.2.2.Static loading, 1.2.2.1.Handlebars 1.2.2.2.Foot supports 1.2.3. Adjustable guide systems, 1.2.4. Control panel, 1.2.5.Warnings and, 1.2.6.Documentation This test method is under the jurisdiction of ASTM Committee F08 and is the direct responsibility of Subcommittee 0.030 Sports Equipment and Facilities. 1.3.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
test method to accompany Elliptical design spec.
Keywords
endurance load testing,
The title and scope are in draft form and are under development within this ASTM Committee.
Citing ASTM Standards
[Back to Top]
