Withdrawn Rationale:
This test method establishes procedures for the evaluation of the chemical resistance of coatings used in light-water nuclear power plants.
Formerly under the jurisdiction of Committee D33 on Protective Coating and Lining Work for Power Generation Facilities, this test method was withdrawn in January 2010 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1. Scope
1.1 This test method establishes procedures for the evaluation of the chemical resistance of coatings used in light-water nuclear power plants.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D714 Test Method for Evaluating Degree of Blistering of Paints
D1193 Specification for Reagent Water
D5139 Specification for Sample Preparation for Qualification Testing of Coatings to be Used in Nuclear Power Plants
D7230 Guide for Evaluating Polymeric Lining Systems for Water Immersion in Coating Service Level III Safety-Related Applications on Metal Substrates
NACE Standard
NACEStandardTM-01-74 Laboratory Methods for the Evaluation of Protective Coatings Used as Lining Materials in Immersion Service
Index Terms
chemical resistance; coatings and linings; nuclear;
DOI: 10.1520/D3912-95R01
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
