ASTM D2938-95(2002)

    Withdrawn Standard: ASTM D2938-95(2002) Standard Test Method for Unconfined Compressive Strength of Intact Rock Core Specimens (Withdrawn 2005)

    Developed by Subcommittee: D18.12

    WITHDRAWN, REPLACED BY D7012

    Buy Standard (PDF)
    3 pages
    $44.40

    Active (view current version of standard)


    Withdrawn Rationale:

    This test method specifies the apparatus, instrumentation, and procedures for determining unconfined compressive strength of intact rock core specimens.

    Formerly under the jurisdiction of Committee D18 on Soil and Rock, this test method was discontinued in May 2005 and replaced by D 7012, Test Method for Compressive Strength and Elastic Moduli of Intact Rock Core Specimens Under Varying States of STress and Temperatures.

    For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards volume information, refer to the standard's Document Summary page on the ASTM website.

    1. Scope

    1.1 This test method specifies the apparatus, instrumentation, and procedures for determining unconfined compressive strength of intact rock core specimens.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    DOI: 10.1520/D2938-95R02

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top