1. Scope
1.1 This test method covers the determination of the property of adhesion of pressure-sensitive tape to a fiberboard surface. The user of this test method has the option of choosing the paper surface for the test. The test surface may be the standard linerboard, another linerboard (or paper) of individual interest, or a specific fiberboard.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1-This test method is the metric counterpart of Test Method D2860. It uses a 24 mm X 24 mm tape area rather than the 1 in. X 1 in. (25.4 mm X 25.4 mm) area used in Test Method D2860. This difference in test parameters will generally produce lower time to failure for Test Method D2860M than Test Method D2860 but not necessarily by a constant factor.
Index Terms
Adhesion-pressure-sensitive tapes; Fiberboard containers; Linerboard; Pressure-sensitive tapes; Stress-adhesives/tapes; Surface analysis-pressure-sensitive tapes; adhesion-pressure-sensitive tape to fiberboard, at 90° angle and; constant stress, test, (for metric see D 2860M),; Containerboard; adhesion-pressure-sensitive tape (at 90° angle and constant; stress), test, (for metric see D 2860M);Order Form;
Citing ASTM Standards
[Back to Top]
