ASTM D1929-96(2001)e1

Withdrawn Rationale:

This fire test response test method covered a laboratory determination of the flash ignition temperature and spontaneous ignition temperature of plastics using a hot-air furnace.

Formerly under the jurisdiction of Committee D20 on Plastics, this fire test response test method was withdrawn in February 2010 in accordance with subsection 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

1.1 This fire test response test method² covers a laboratory determination of the flash ignition temperature and spontaneous ignition temperature of plastics using a hot-air furnace.

1.2 Caution-During the course of combustion, gases or vapors, or both, are evolved that may be hazardous to personnel. Adequate precautions should be taken to protect the operator.

1.3 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazards or fire risk assessment of materials, products, or assemblies under actual fire conditions.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 1.2 and 1.4.

Note 1- This test method and ISO 871-1996 are identical in all technical details.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

International Standards

Index Terms

flash ignition temperature; ignition temperature; spontaneous ignition temperature;

Citing ASTM Standards

[Back to Top]