You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM A569/A569M-98

    Standard Specification for Steel, Carbon (0.15 Maximum, Percent), Hot-Rolled Sheet and Strip Commercial (Withdrawn 2000)

    Withdrawn Standard: ASTM A569/A569M-98 | Developed by Subcommittee: A01.19


      Format Pages Price  
    PDF 2 $48.00   ADD TO CART


    1. Scope

    1.1 This specification covers hot-rolled carbon steel sheet and strip of commercial quality, in coils and cut lengths, having a maximum carbon of 0.15%. This material is intended for parts where bending, moderate forming or drawing, and welding may be involved.

    1.2 This specification is not applicable to the steel covered by Specification A635/A635M.

    1.3 The values stated in either acceptable metric units (SI) or in inch-pound units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0569_A0569M-98

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM A569 / A569M-98, Standard Specification for Steel, Carbon (0.15 Maximum, Percent), Hot-Rolled Sheet and Strip Commercial (Withdrawn 2000), ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top